Muratec MFX-1500 - Manual (Page 126)

Just in case …
3.6
Printouts have irregularities
• The paper you’re using may have absorbed moisture, perhaps
due either to high humidity or water having been spilled on the
paper supply at some point. Toner will not adhere well to paper
at the location where the paper has been wet.
Replace the paper with dry paper and re-try the printing.
Printouts have white and/or black lines
•
The toner cartridge or drum cartridge may be defective.
Remove and check the cartridge for damage.
If the problem persists, replace either or both of the cartridges
as indicated.
•
The charger may be dirty.
Your machine normally cleans the charger automatically.
If other solutions fail, please contact your authorised Muratec
dealer.
Printouts have toner smudges
• The toner may be unevenly distributed inside the toner cartridge.
Remove the toner cartridge and shake it a few times to
redistribute the toner inside. If the problem persists, replace the
cartridge.
•
The toner cartridge or drum cartridge may be defective.
Remove and check the cartridges for damage. If the problem
persists, replace either or both of the cartridges as indicated.
•
If you find smudges on the back of the printouts, the transport
roller may be dirty.
Your machine normally cleans the transport roller
automatically. If other solutions fail, please contact your
authorised Muratec dealer.
Printouts have white spots
• The charger may be dirty.
Your machine normally cleans the charger automatically. If
other solutions fail, please contact your authorised Muratec
dealer.