Muratec MFX-1500 User Manual
Page 83
Beyond the basics
2.35
7.
The LCD now indicates the Mercury pause time, for which your fax is set:
Set Prefix Pause
Time (00-11): 05
This is used to enter the Mercury pause time in the event of the Mercury dial
tone not being recognised.
If the setting you see is acceptable, skip to step 9.
Otherwise, proceed to step 8.
8.
Use the numeric keypad to enter the delay that you require. If the delay is
00-09, be sure to enter the leading zero. We suggest a setting of 5 seconds
(05):
Set Prefix Pause
Time (00-11): 05
9.
Press
ENTER
to save the setting.
Note:
You can adjust your fax for a delay of 1 to 11 seconds depending upon your
local telephone conditions. To test your exchange for the delay required dial
131 from a telephone and time the delay between dialling and hearing the
Mercury tone in your handset.
To check that you have programmed the
Blue
key correctly, press
Blue
key, dial
your chosen cost centre code digits (if applicable) and dial 1500 on the keypad. You
should be connected to a recorded message. If not repeat the above programming
procedure, increasing the length of the pause.
If you still have problems, please call the Cable & Wireless customer services free of
charge on 0500-500-193 (Technical Services Number).
Mercury access via 132 code (Residential 132 service)
In some areas of the country you can access the Mercury network by simply dialling
132 and dialling the full national number. It is not necessary to enter your PIN
number because the telephone exchange can transfer your telephone number
electronically to Mercury for billing.
For 132 Mercury access and to avoid the need to dial 132 before each and every call.
Please program your fax as follows:
1.
If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY
/
FAX
to change to Fax mode.
2.
Press
PROGRAM
,
J
, 2, 0,
ENTER
.
Dial Prefix No 03
_
The number you see in the right of the display tells you how many characters
you have entered into the Mercury number before.
3.
Enter the Mercury access number 1, 3, 2 on the numeric keypad.
Dial Prefix No 03
132_
4.
Press
ENTER
to save the number and continue.
5.
The LCD now indicates the Mercury pause time, for which your fax is set:
Set Prefix Pause
Time (00-11): 05
Note:
A delay is not required between dialling the 132 Mercury access code
and the national telephone number when using 132 access to Mercury.
If the setting you see is acceptable, skip to step 7.
Otherwise, proceed to step 6.
6.
Use the numeric keypad to enter the delay that you require. If the delay is
00-09, be sure to enter the leading zero. We suggest a setting of 0 seconds
(00):
Set Prefix Pause
Time (00-11): 00
7.
Press
ENTER
to save the setting.
To ensure that you have successfully accessed the Mercury network, press
Blue
key
and dial 132. You should be connected to a recorded message welcoming you to
Mercury. If you require any assistance please call Cable & Wireless customer services
on 0500-500-193 free of charge.