Muratec MFX-1500 - Manual (Page 19)

Getting started
1.10
Removing the transport screws
Your fax machine is shipped with transport screws for protecting your fax machine’s
mirror carriage during shipping.
Important: Be sure that you do not turn the power on until after you have removed
the transport screws. Otherwise, damage could result.
1. Remove the four transport screws, as shown.
2. Get the protection seals from your manual kit, and attach one protection seal
on each transport screw’s now-open hole. This shields the hole while you are
using the machine.
Important: Before you use the machine, you must turn off the transport mode (see
page 1.17).
Note: Be sure to save the screws for reshipment. If you must ship your machine for
some reason, turn off the transport mode, turn the power off and then undo
the above procedure as follows:
— Remove the seals (reversing step 2);
— Reinstall the screws (reversing step 1).
Installing the printing supplies
Your fax machine prints incoming faxes and copies with a high-speed laser print
engine. The engine requires two types of printing supplies, or consumables:
•
The drum cartridge — It yields up to 10,000 normal A4-sized printouts (see
“Specifications,” page
AI .1). By “normal,” we’re referring to the amount of
text and/or graphics on each page. This is based on an industry-standard test
document.
•
The toner cartridge — It yields up to 10,000 such printouts (see
“Specifications,” page
AI .1).
Here’s how to install these supplies:
1. Open the top cover.
2. Open the printer
cover.