Muratec MFX-1500 - Manual (Page 132)

Just in case …
3.12
“Check Message” printouts
When a fax call goes awry and your machine detects an error, it produces an error
printout headed by the words “Check Message”. This printout lists the following
information about the transmission:
•
The resulting error code
• A communications error message (see previous page)
•
The phone number (or, perhaps, TTI ) of the fax machine with which your machine
had attempted to communicate
What error messages can mean
The error messages on Check Message printouts can mean a variety of things.
Here’s a brief summary:
Error Message Possible Meanings
Check condition of remote fax •
Remote machine malfunctioned
•
No “handshake” signals from remote fax
•
Wrong phone number reached
Repeat transmission • Poor phone line conditions
•
No “handshake” signals from remote fax
•
Document misfeed or miscount
•
Unable to reach remote machine after
attempting specified number of redial tries
Line is busy •
Remote machine’s line was busy
•
Remote machine’s line didn’t answer
Check received documents • Receive confirmation signal not received
from remote fax
•
Poor line conditions caused a poor image
Memory full • Remote fax’s memory capacity exceeded
Dialling number is not set •
Stored phone number failed to dial
properly
Stopped •
Someone pressed STOP at the remote fax
in the middle of the “handshake”