Muratec DIGITAL LASER F-114 - Manual (Page 139)

Adjustment and Troubleshooting
Service Manual
4-79
2) Abnormal Printing
1. Set up the parallel port
using CMOS SETUP.
Ensure that ECP (best) or SPP is selected
in the CMOS (BIOS) setup.
Ensure that the correct driver is loaded.
Use the driver supplied on the CD or
downloaded from the web site.
DO NOT use the Microsoft driver supplied
with the Windows operating system. If the
printer is a GDI or SPL type printer ensure
that ALL OTHER GDI or SPL drivers are
uninstalled as Windows allows only 1 of
this type of driver to be loaded.
Delete any unnecessary files to secure
enough space on the hard disk and start
the print job again.
2. Printer Driver Error.
3. Error message
“insufficient memory”.
(The printing job sometimes stops due to
insufficient virtual memory, this is
caused by insufficient space
on the hard
disk.)
Description: Printing does not work – even after replacing the cable
Printer does not work at all or strange fonts are printed,