Mercedes-Benz CS1000 User Manual
Page 131
8
-
9
-
10
DM
CS1000 Code Scanner
OB15-11
131
!' &
!' &
!' &
!' &
SEE ME-SFI INJECTION FOR ALL DIAGNOSTIC CODES FROM 8/96 PRODUCTION AND LATER FOR
ALL MODELS.
Engines
Model Years
104 119 120
1991-96
Connect wires of Scanner as follows
Scanner
Data Link Connector 16-pin
Yellow
Socket 3
Black
Socket 1
Red
Socket 16
Scanner
Data Link Connector 38-pin
Yellow
Socket 19
Black
Socket 1
Red
Socket 3
DM
8 for “Current”,
9 “Stored” and
10 “Registered” Fault Codes
DTC Readout
Possible Cause of Failure
000
No fault found
002
Oxygen sensor. No signal (right bank in 120)
003
Fuel adaptation (lambda control), inoperative. Engine control module (right bank in 120)
004
Air injection defective, fault from Fuel control system (right bank in 120)
005
EGR exhaust gas recirculation incorrect, fault. Engine control module (right bank in 120)
006
Idle speed control incorrect, fault from EA/CC/ISC
007
Ignition system defective, fault from Fuel/Ignition control system (right bank in 120)
008
Coolant temperature sensor signal. Open or short circuit (right bank in 120)
009
Intake air temperature sensor signal. Open or short circuit (right bank in 120)
010
Air mass sensor voltage signal too high /low. (right bank in 120)
011
Engine speed signal TN (RPM) or Engine control module (right bank in 120) defective
012
Oxygen sensor heater circuit. Open or short circuit (right bank in 120)