Mercedes-Benz CS1000 - Manual (Page 158)

2 Transmission Module
CS1000 Code Scanner OB15-12
DTC Readout Possible cause of Failure
Copyright © 1998 Baum Tools Unlimited Inc. All rights reserved.
Reproduction in whole or in part in any form or medium without express written permission of Baum Tools Unlimited Inc. is prohibited.
158
32 CAN data: Left engine torque from ME-SFI controller system incorrect/implausible
33 CAN data: Communication to/from the ME-SFI controller is faulty
33 CAN data: Throttle valve actuator actual value from ME-SFI incorrect/implausible
34 CAN data: Communication to/from the ME-SFI controller is faulty
35 CAN data: Communication to/from the ME-SFI controller is faulty
36 CAN data: Communication to/from the ME-SFI controller is faulty or the engine
temperature is implausible.
37 CAN data: All communications are faulty
38 CAN data: Communication to/from the Traction system controller is faulty
39 CAN data: Communication to/from the ME-SFI controller is faulty
40 CAN data: Communication to/from the Instrument Cluster is faulty
50 Speed sensor n3 or clutch K1 are faulty
51 Gear implausible or transmission slips.
52 Command valve (6, 14, or 25) sticking under pressure.
52 Unauthorized locking of Torque Converter lock-up clutch. Replace Torque Converter.
53 Torque converter lock-up clutch, not functioning. Replace Torque Converter.
53 Torque converter lock-up clutch, input (RPM) too high. Replace Torque Converter.
54 No feedback signal from transmission overload protection.
55 Gear comparison incorrect or target gear selection not achieved.
56-65 Transmission control unit (N15/3) faulty .
98-155 These codes are intermittent. To establish their meaning, subtract 96 from the code
number given and look in the table above for the definition of the intermittent fault.