Mercedes-Benz CS1000 - Manual (Page 151)

Mercedes Benz
Transmission Module
CS1000 Code Scanner OB15-12
Copyright © 1998 Baum Tools Unlimited Inc. All rights reserved.
Reproduction in whole or in part in any form or medium without express written permission of Baum Tools Unlimited Inc. is prohibited.
151





2 Digital type Transmission Systems as follows:
Models 202, 210, 129, 140 with HFM-SFI, ME-SFI control system 1994 - 1997
Press the SYSTEM key to scroll to display from





1 to





2 system.
SYSTEM
ANALOG TEST PROCEDURES
1. Ignition in the KOEO position (Key On Engine Off).
2. Choose system





1.
3. Place test probe (yellow) in pin-out for specific analog test.
DIGITAL TEST PROCEDURE
1. Ignition in the KOEO position (Key On Engine Off)
2. Choose system



2.
3. Place test probe (yellow) in pin-out for Digital test.
4. If any system does not respond, test it using the Analog Test Procedure.
*Some early LH Injection and Diagnostic Module systems may not respond to the digital test.
4. Read Fault Codes
Press the READ key to begin to read the fault codes for the system selected. The scanner will scan all of
the fault codes and keep them in memory.

When reading Digital Fault Codes the scanner will display a U 1 or a U 2 indicating the type of
digital system it has discovered. Refer to the U codes displayed on the top of the code pages to
identify the system.
READ
Press the NEXT key to scroll through the fault codes

xx . The display will cycle to the first code after
the last code is displayed. When there are no faults in the system,

0 will be displayed on the screen.
NEXT
5. Identification/Rectification of Faults
1. Identify fault code and related circuit using this manual or using the factory diagnostic manuals