Mercedes-Benz CS1000 - Manual (Page 45)

1
ANALOG CODES
CS1000 Code Scanner OB15-11
45
#(# '

#(# '

#(# '

#(# '

Models Model Years
124.034 124.036 1992-1995
129.067 129.076 1992-1995
140.042 140.043 140.051 140.057 140.070 140.076 1992-1995
Connect wires of Scanner as follows
Scanner Data Link Connector 38-pin
Yellow Socket 17
Black Socket 1
Red Socket 3
FAULT CODE TABLE
DTC Readout Possible Cause of Failure
1 No fault found
2 Maximum retard setting on at least one cylinder has been reached
3 Not used
4 Load sensor in EAL/AKR control module faulty
5 Knock sensors 1 and/or 2 faulty
6 Camshaft position sensor faulty
7 Knock output switch in ignition control module faulty
8 Transmission overload switch does not close
9 Transmission overload switch does not open
10 Not used
11 Reference resistor (ignition control module ) faulty
12 TN-signal (engine RPM) is outside the tolerance range
13 Not used
14 Not used
15 Ignition coil 1 output from ignition control module faulty or primary winding of ignition
coil has open circuit
16 Ignition coil 2 output from ignition control module faulty or primary winding of ignition
coil has open circuit