Mercedes-Benz CS1000 - Manual (Page 35)

1
ANALOG CODES
CS1000 Code Scanner OB15-11
35
!' &

!' &

!' &

!' &

Models Model Years
124.034 124.036 1992-1993
119.067 1992-1995
140.032 140.042 140.043 140.051 1992-1995
Connect wires of Scanner as follows
Scanner Data link connector 38-
pin
Yellow Socket 19
Black Socket 1
Red Socket 3
FAULT CODE TABLE
DTC Readout Possible Cause of Failure
1 No fault found
2 Oxygen sensor faulty
3 Lambda control faulty
4 Air injection system faulty
5 Exhaust gas recirculation faulty
6 Idle speed control faulty
7 Ignition system faulty
8 Engine coolant temperature sensor. Circuit open or circuit short
9 Intake air temperature sensor. Circuit open or circuit short
10 Voltage at mass air sensor too high/low
11 TNA-signal (rpm signal ) faulty
12 Oxygen sensor greater, circuit open or circuit short
13 Camshaft position sensor signal from ignition control module faulty
14 Intake manifold pressure too low when starting
15 Wide open throttle position information faulty
16 Closed throttle position information faulty
17 Data exchange fault between individual control module
18 Adjustable camshaft timing solenoid circuit open or circuit short