Mercedes-Benz CS1000 - Manual (Page 66)

1
ANALOG CODES
CS1000 Code Scanner OB15-11
66
!(# / "
  !(# / "
  !(# / "
  !(# / "
 
Model Model Years
124.066 1993-95
Connect wires of Scanner as follows
Scanner Data Link Connector
Yellow Power Soft top test connection (4 pole) at Socket 2. The connection is located at the right front
passenger footwell. To avoid the need for an extension cable, connect the black lead of code scanner
to any good ground and red lead to a battery + source inside vehicle.
Black Socket 1
Red Socket 16
FAULT CODE TABLE
DTC Readout Possible Cause of Failure
1 No fault found
2 Volts low
3 Normal operating time exceeded
4 Limit switch signals Illogical
5 Soft top compartment cover "locked", limit switch,
6 Soft top compartment cover "closed", limit switch,
7 Soft top compartment cover "open", limit switch
8 Soft top fabric bow "locked", limit switch
9 Soft top fabric bow "down", limit switch
10 Soft top fabric bow "raised", limit switch
11 Left front soft top "locked", limit switch
12 Right front soft top "locked", limit switch
13 Soft top "open" switch (soft top in storage compartment), limit switch ,
14 Soft top "overhead", limit switch
15 Soft top "retracted", limit switch
16 Roll bar "extended", limit switch,
17 Automatic deployment of roll bar has occurred
18 Power soft top switch
19 Vehicle speed signal
20 Circuit in power soft top control module, solenoid valve, roll bar retracted
21 Circuit hydraulic unit, circuit solenoid valve, roll bar retracted
22 Circuit in power soft top control module, solenoid valve, roll bar extended
23 Circuit solenoid valve, roll bar extended
24 Circuit in power soft top control module, Power windows