Mocomtech CIM-550 - Manual (Page 257)

CiM-550 IP Enabled Satellite Modem Rev. 2
SNMP interface CD/CIM550.IOM
231
13.4.1.5 E
NCRYPTION
S
UBGROUP
Note: This subgroup will only be accessible in the MIB tree if the Encryption FAST feature has
been purchased and the license key has been entered through the modem’s front panel.
Otherwise, both GETS and SETS on these OIDs will return errors.
This subgroup controls the parameters for the DES feature.
Table 13-20. Encryption Subgroup OIDs
OID Description
cimTransmitEncryptEnabled Enables/disables encryption on the transmit side.
cimReceiveDecryptEnabled Enables/disables encryption on the receive side.
cimTransmitKey1 Allows the operator to specify the value of Key1 used to
encrypt packets transmitted to the sattelite.
cimTransmitKey2 Allows the operator to specify the value of Key2 used to
encrypt transmitted packets transmitted to the sattelite.
cimReceiveKey1 Allows the operator to specify the value of Key1 used to
decrypt traffic being received from the Satellite Interface.
cimReceiveKey2 Allows the operator to specify the value of Key2 used to
decrypt traffic being received from the Satellite Interface.
13.4.1.6 C
I
M SMTP
The cimSmtp subsection sets up the cim550 to use a SMTP mail server to send a problem
report back to CiM Support. Along with the problem report, the cim550 sends the
equipment serial number and configuration, which is attached to the email message. By
default, the problem report is sent to
[email protected] . In order for this to
work, the user is required to enter the IP address of their outgoing SMTP mail server and
the domain name for that server.
Table 13-21. CIM SMTP OIDs
OID Description
cimSmtpServerIpAddress Specifics user’s outgoing SMTP server’s IP address.
cimSmtpDomain Specifics the SMTP Domain of the mail server.
cimSmtpDestinationName Specifies the SMTP destination user name.