Mocomtech CIM-550 - Manual (Page 33)

CiM-550 IP Enabled Satellite Modem Rev. 2
Introduction CD/CIM550.IOM
7
FEC
FEC None: Uncoded BPSK/QPSK/OQPSK
Viterbi: k=7, per IESS 308/309
BPSK: Rate 1/2
QPSK/OQPSK: Rate 1/2, Rate 3/4 and Rate 7/8
Sequential:
k=36 (Rate 1/2) per IESS 309
k= 63 (Rate 3/4) per IESS 309
k= 87 (Rate 7/8)
Turbo Product Codec (Optional plug-in card):
Rate 3/4 QPSK - 2 dimensional
Rate 21/44 BPSK - 3 dimensional
Rate 5/16 BPSK - 3 dimensional
Overhead Framed
EDMAC/AUPC 5% overhead (Except Turbo BPSK modes, which add 1.5%)
AUPC Target Eb/No Range: 0 to 9.9 dB
Max AUPC Range: 0 to 9 dB
Monitor Functions Distant end Eb/No Tx power level increase
Miscellaneous
Front panel Tactile keypad, 6 keys (Up/Down, Left/Right, Enter/Clear)
Vacuum Fluorescent Display (blue) - 2 lines of 24 characters
Loopbacks Internal IF, digital, and near/far
Fault relays Hardware fault, Rx and Tx Traffic Alarms
M&C Interface EIA-232 and EIA-485 (addressable multi-drop)
EIA-485 may be either 2-wire or 4-wire
RJ-11 Command Line Interface (CLI) for control of IP configuration
parameters.
M&C Software EDMAC software for control of local and distant units
NETWORKING PROTOCOLS 1
Address Resolution Protocol (ARP) Configurable static ARP entries
Internet Protocol (IP)
Internet Control Message Protocol (ICMP)
IPv4 Routing Configurable static routes
Internet Group Management Protocol (IGMP v1 & v2)
User Datagram Protocol (UDP)
Transmission Control protocol (TCP)
Simple Network Management Protocol (SNMP v2)
Telnet