Transmit and receive if configuration, Basic ip configuration, If c – Mocomtech CIM-550 User Manual
Page 447: Ip c
CiM-550 IP Enabled Satellite Modem
Rev. 2
CiM IP Module Checkout & Fault Isolation
CD/CIM550.IOM
421
14.2.3 T
RANSMIT AND
R
ECEIVE
IF C
ONFIGURATION
Step Procedure
1
Configure the transmit and receive IF parameters on CiM 1 and CiM 2 via the front panel.
Note: The IF parameters can also be set via console menu, Telnet, web interface and SNMP -
but for this exercise, it is recommended that the front panel be used.
2
Set the TxPower to minimum level.
3
Before proceeding to next step, make sure that each CiM is locked to the other CiM.
14.2.4 B
ASIC
IP C
ONFIGURATION
Step Procedure
1
Launch the terminal emulation program - such as HyperTerminal on Microsoft Windows.
2
Select the appropriate COM port (to which the DB-9 end of the console cable is
connected) and configure it for:
38,400 bps
8 data bits
no parity
1 stop bit
no hardware flow control
3
Press return and to bring up the Main menu.