Monarch Instrument 9460 - Manual (Page 24)

2-14 System Administrator’s Guide
Setting the Command Escape Character
This option allows you to set or view the Command Escape Character (CEC).
Run-time messages from the radio begin with the CEC and the default is the
pound sign (#), which has a decimal value of 35. You may need to change
the default CEC character if it conflicts with other data, because an
unexpected operation could occur. The range is a decimal value between 1
and 255.
1. From the Configure menu, select Escape.
Escape Char
+ 35
E R +
Use A as shown in the following table:
E
Press A to
R
Press A to
+
Press
A to
Saves the setting Scrolls through the
positions from left to right Increments the current
position setting by 1
2. When the setting you want is displayed, press A under E to save the
setting. You return to the Configure menu.
3. Press F to exit.
When you select “Exit” after configuring, you will see
Configure
Save Settings?
E X
To save all the configuration settings, press A under E. To exit without
saving the configuration settings, press A under X. Press F until you see
“Ready.”
Note: You must reset the RF network before your changes take effect.
See “Resetting the RF Network” for more information.