Monarch Instrument 9460 - Manual (Page 53)

Using a Web Browser 4-19
C o n t r o l l i n g I P A c c e s s
You can limit which remote hosts are able to access the printer by setting up
an IP address range.
1. From the side menu, click Admin. The Web Admin Configuration screen
appears.
2. Click Configure IP Access Control.
To Add Hosts:
You can specify the valid range of remote IP addresses.
1. Enter a range of remote IP addresses that are allowed access to the
printer. Any requests from hosts outside this range are rejected.
2. Click Add.
3. Click the reset link at the bottom of the screen. The Reset Server screen
appears.
4. Click Submit and wait five seconds for the print server to reset. Even
though you submitted your changes, they do not take effect until you
reset the print server.
You must re-enter your access password to make any further changes to
the printer settings.
The range of accepted IP addresses is listed in the drop-down menu.