Monarch Instrument 9460 - Manual (Page 48)

4-14 System Administrator’s Guide
SNMP Netware Traps
You can configure the SNMP Netware traps.
1. From the Alerts and Traps screen, click SNMP Netware Traps.
2. Enter a community name, IPX address, IPX Node address, and the
trigger conditions for an email alert. You can enter up to four IPX
addresses.
Note: The S1 port acts as a toggle switch to enable or disable the alerts.
You must select S1 to enable the alerts.
3. Click Submit.
4. Click the reset link at the bottom of the screen. The Reset Server screen
appears.
5. Click Submit and wait five seconds for the print server to reset. Even
though you submitted your changes, they do not take effect until you
reset the print server.
You must re-enter your access password to make any further changes to
the printer settings.