Monarch Instrument 9460 - Manual (Page 73)

Telnet Console Commands 6-1
T E L N E T C O N S O L E C O M M A N D S
Use this chapter to configure the print server using Telnet. You
must have a basic understanding of Telnet commands. For initial setup, do
not use Telnet. Use Auto-discover mode. Once you have the IP address,
you can use Telnet or a Web browser.
You can use Telnet if you do not have access to the NetManager software.
Note: The default port is Port 23.
To access Telnet console mode:
1. Start Telnet.
2. Press Enter (on your host) until you see the “#” prompt.
3. Type access as the password and press Enter. (access is the default
password.)
4. Press Enter to by-pass the user name. You do not need to enter a
username.
Note: The Telnet session times out after 10 minutes of inactivity.
6