Motorola III - Manual (Page 33)

32 General Radio Features Operation
(cont.)
32
Scan Operation (cont.)
Deleting Nuisance Modes
When the radio scans to a mode that you do not wish to hear (nuisance
mode), you can temporarily delete the mode from the scan list.
1. When the radio is locked onto the mode to be deleted, press the nuisance-
mode delete button (programmed through the RSS). A valid-keypress chirp is
heard, indicating that the mode has been deleted.
Note: Priority modes cannot be deleted.
2. The radio continues scanning the remaining modes in the list. To resume
scanning the deleted mode, you must leave and reenter scan operation.
Dynamic Priority Change (Conventional Operation Only)
While the radio is scanning, the dynamic priority change feature lets you
temporarily change any mode in a scan list (except the priority 1 mode) to the
priority 2 mode. The present priority 2 mode becomes a non-priority mode. This
change remains in effect until scan is turned off, then scanning reverts back to
the preprogrammed state.
1. When the radio is locked onto the mode to be designated as priority 2, press
the dynamic priority button (programmed through the RSS). A valid-keypress
chirp is heard, indicating that the priority change has occurred.
Note: The priority 1 mode cannot be changed to priority 2.
2. The radio continues scanning the remaining modes in the list. To resume
scanning the preprogrammed priority 2 mode, you must leave and reenter
scan operation.