Intel IXM5414E - Manual (Page 179)

Intel® Blade Server Ethernet Switch Module IXM5414E 169
Enable -
traps will be sent
Disable -
traps will not be sent.
System configuration
Network connectivity
config network javamode
Use this command to enable or disable the java applet that displays a picture of the switch module at
the top right of the screen when you are using the Web interface. If you run the applet you will be
able to click on the picture of the switch to select configuration screens instead of using the
navigation tree at the left side of the screen. The factory default is enabled.
Default enable
Format config network javamode <enable/disable>
config network parms
Use this command to set the IP Address, subnet mask and gateway of the router. The IP Address and
the gateway must be on the same subnet.
Default 10.90.90.9x 255.255.255.0 0.0.0.0
Format config network parms IPaddress netmask [gateway]
config network protocol
Use this command to specify the network configuration protocol. Select DHCP, BootP, or None. The
change is effective immediately.
Default none
Format config network protocol none/bootp/dhcp
Values none The network interface is manually configured with static IP information.
bootp The network interface is configured to acquire an IP configuration using the
Bootstrap Protocol (BootP).
dhcp The network interface is configured to acquire an IP configuration using the
Dynamic Host Configuration Protocol (DHCP). If you select DHCP and
management of the Ethernet switch module through the four ports is enabled, the
switch module will acquire its IP address, network mask, and default gateway from
a DHCP server when the switch module is turned on or reset.
config network webmode
Use this command to enable or disable access to the switch module via the Web interface. When
access is enabled a user can login to the switch from a web browser through TCP port 80. Disabling
access takes effect immediately on all interfaces.
Default enable
Format config network webmode <enable/disable>