Intel IXM5414E - Manual (Page 194)

184 Intel® Blade Server Ethernet Switch Module IXM5414E
transfer download path
Use this command to specify the directory path on the TFTP server where the file to be downloaded
to the switch is located. The switch will remember the last file path used.
This command is valid only when the Transfer Mode is TFTP. See transfer download mode.
Details of the TFTP path are explained under the command transfer upload path.
Format transfer download path <path>
transfer download serverip
Use this command to configure the IP address of the server on which a file to be downloaded is
located.
This command is valid only when the transfer mode is TFTP. See transfer download mode.
Default 0.0.0.0
Format transfer download serverip <ipaddr>
transfer download start
Use this command to start a download transfer. After the current settings are displayed you will be
prompted to confirm your decision. This command will close your connection to the host.
Format transfer download start
The following information fields are displayed:
TFTP Server IP
The IP address of the server where the file is to be downloaded.
TFTP Path The directory path specification for the file to be downloaded.
TFTP Filename
The name of the file to be downloaded.
Data Type The type of file to be downloaded: config, error log, message log or trap log.
Transfer upload commands
TFTP upload example
This example shows three ways to specify the same TFTP client-to-server file transfer. Each
scenario involves uploading the config.bin file from the switch to the location c:\tftp\ on the server.
The different scenarios are shown below:
The directory path statement can be cleared by issuing the clear config command.
Format transfer upload path <path>
Table 5. TFTP Upload Scenarios
TFTP Server path TFTP Client path
c:\tftp\ blank
c:\ tftp\
c: \tftp\