Intel IXM5414E - Manual (Page 98)

88 Intel® Blade Server Ethernet Switch Module IXM5414E
Upload file from switch
Use this panel to configure the information needed to upload a file from the switch. See the previous
menu option “Download file to switch” on page 86 for more information about specifying TFTP File
Paths and Names.
File Type
This field sets the type of file to be uploaded from the switch. The datatype is one of the
following:
config Configuration file
errorlog Error log
msglog Message log
TFTP Server IP Address
Enter the IP address of the TFTP server. The factory default is 0.0.0.0.
TFTP File Path
This field specifies the directory path on the TFTP server where the file to be uploaded from
the switch is to be located. The switch will remember the last file path used.
TFTP File Name
This field specifies the name of the file that is to be uploaded from the switch. The switch
will remember the last file name used.
The last row of the table is used to display information about the progress of the file transfer. The
screen will refresh automatically until the file transfer completes.
Click the Start File Transfer button to apply any changes made to the fields and initiate the upload.
Click the Apply button to send the updated screen to the switch; this does not perform the file
upload. This command is valid only when the transfer mode is TFTP.