Intel IXM5414E - Manual (Page 183)

Intel® Blade Server Ethernet Switch Module IXM5414E 173
User Access Mode
Shows whether the user is able to change parameters on the switch (Read/write) or
is only able to view them (Read-only). As a factory default, admin has Read/write
access and guest has Read-only access. There can only be one Read/write user and
up to five Read-only users.
SNMPv3 Access Mode
Displays the SNMPv3 Access Mode. If the value is set to Read/write, the SNMPv3
user will be able to set and retrieve parameters on the system. If the value is set to
Read-only, the SNMPv3 user will only be able to retrieve parameter information.
The SNMPv3 access mode does not have to be the same as the CLI and Web access
modes.
SNMPv3 Authentication
The protocol (if any) that will be used to authenticate the user.
SNMPv3 Encryption
The encryption protocol (if any) that will be used for the authentication process.
Login
config loginsession close
Use this command to close a specified Telnet session.
Format config loginsession close <sessionid/all>
show loginsession
Use this command to display currently active Telnet and serial port connections to the switch.
Format show loginsession
ID Login Session ID
User Name The account name used to login via the serial port or Telnet.
Connection From
The IP address of the Telnet client machine or EIA-232 for the serial port
connection.
Idle Time Time this session has been idle.
Session Time
Total time this session has been connected.
System description
config prompt
Use this command to change the prompt that is displayed when you use the CLI. You may enter up
to 64 alphanumeric characters.
Format config prompt <system prompt>