Integra DPS-10.5 - Manual (Page 19)

19
Getting to Know the DPS-10.5 —Continued
G VIDEO OUT S VIDEO (27)
These two sockets output S-Video and can be con-
nected to an S-Video input on a TV or projector.
H VIDEO OUT VIDEO (27)
These two sockets output composite video and can
be connected to a composite video input on a TV or
projector.
I DIGITAL 1 AUDIO OUT (32, 34)
These sockets output digital audio and can be con-
nected to the digital audio input on a hi-fi amp, AV
receiver, surround sound decoder (Dolby Digital,
DTS), or other component. There’s a coaxial output
and an optical output.
J DIGITAL 2 AUDIO OUT (32, 34)
These sockets output digital audio and can be con-
nected to the digital audio inputs on a hi-fi amp, AV
receiver, surround sound decoder (Dolby Digital,
DTS), or other component. There’s a coaxial output
and an optical output.
K IR IN/OUT (36)
The IR IN socket can be used to connect a commer-
cially available IR receiver, which can be used to
pickup signals from the remote controller when the
DPS-10.5 is located in another room, installed in a
rack, or is out of range of the remote controller
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other components.
L REMOTE CONTROL (36)
These (Remote Interactive) sockets can be con-
nected to the sockets on other Integra AV com-
ponents for interactive control.
To use you must make an analog audio connec-
tion between the DPS-10.5 and your Integra AV
receiver, even if they are connected digitally.
M D.MIX AUDIO OUT (27, 28, 34)
These sockets output analog audio and can be con-
nected to a stereo analog audio input on a TV, hi-fi
amp, or other component. If the source audio is
multichannel (Dolby Digital, DTS, DVD-Audio,
SACD), they output a 2-channel downmix.
N FRONT, SURR 1, CENTER & SUBWOOFER
AUDIO OUT (33)
These sockets output 5.1-channel analog audio and
can be connected to a 5.1-channel analog audio
input on an AV receiver, surround sound decoder
(Dolby Pro Logic), or other component.
O SURR 2 AUDIO OUT (33)
These sockets output the same analog audio as the
SURR1 outputs and can be connected to the analog
surround back left and right inputs on a 7.1-channel
AV receiver or other component. When using these
sockets, the SURR MODE switch should be set to
1+2.
P SURR MODE (AUDIO OUT) switch (33)
This switch is used to set the surround output mode
of the analog multichannel audio outputs. If you
connect the SURR 2 outputs to a 7.1-channel AV
receiver or amp, set this switch to 1+2. This reduces
the output level by 3 dB. If you’re not using the
SURR 2 outputs, set this switch to 1.
Q HD VIDEO OUT COMPONENT (28)
These BNC sockets output HD component video
and can be connected to the HD component video
input on an HDTV or projector.
When a video signal is fed to a VIDEO IN socket
(S-Video or composite), and the video input source
is set to External, that video signal is upconverted to
progressive and output here.
R 12V TRIGGER IN
This socket can be connected to the 12-volt trigger
output on an AV receiver or other component so that
the DPS-10.5 can be turned on remotely.
S AC INLET (37)
The supplied power cord should be connected here.