Integra DPS-10.5 - Manual (Page 75)

75
Configuring the DPS-10.5 —Continued
Setting Levels With the Test Tone AV Synchronization
When using progressive scanning you may find that the
picture and sound are out of sync. With this setting you
can delay the audio to correct this. There are three setup
memories (1, 2, 3) for storing settings for up to three
components. Memories 2 and 3 are already set at 50 ms,
which is a good staring point when compensating for the
video delay caused by a typical projector with a built-in
scaler.
Selecting the AV Synchronization
1 Use the Up and Down [ ]/[ ]
buttons to select Test Tone, and
then press the [Enter] button.
The Test Tone settings appear onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select each speaker,
press the [Enter] button, use the
Left and Right [
]/[ ] buttons to
adjust the levels, and then press
the [Enter] button.
A test tone is output by each speaker as
it is selected.
Speaker levels can be adjusted in 1 dB
steps.
You cannot set the level of speakers that
are set to Off.
3 When you’ve finished, press the
[Setup] button to exit setup, or
press the Left [
] button repeat-
edly to go back to the main setup
menu.
Enter
Remote controller
Enter
Remote controller
Speaker Range Default
Front Left
–12 dB to
0 dB
0 dB
Center
Front Right
Surround
Right
Surround Left
Subwoofer
Remote controller
1 Use the Up and Down [ ]/[ ]
buttons to select setup 1, 2, or 3,
and then press the [Enter] or
Right [
] button.
The parameters appear onscreen.
+10 0 Clear
1 2 3
4 5 6
7 8 9
Input I
+
-
Enter
Set up Retu rn
L 4
L 2 L1 V Off V In
Aspect A-B Repeat
Rsltn Angle Subtitle Audio
L 3
To p M enu Men u
VOL
+
-
V3
TV
Input D M S
DVD Amp VCR
DVD V1 V 2
LM RD
Zoom
CH
L Mode
Learning
Search Memory Dimmer Amp Input
Display
Audio
Sel
Zoom On Picture Control
Random Step/Slow
Muting
Angle Subtitle Audio
Aspect A-B Repeat
On Standby T V
T V CH
T V VOL
RC-562DV
Last Memory
Resolution
Mode
Amp Input
Rec
Open/Close
Video Input Video Off
Enter
Setup