Integra DPS-10.5 - Manual (Page 34)

34
Connecting —Continued
This section explains how to connect the DPS-10.5 to a
stereo hi-fi amp or receiver for sound quality better than
that provided by most TVs. This is great for listening to
your CDs and MP3s. DVD-Video discs and VCDs will
sound better too. You can also enjoy Dolby Surround, if
your receiver supports Dolby Pro Logic.
L. Analog Connection
Use an RCA audio cable to connect the DPS-10.5’s
D.MIX AUDIO OUT to a stereo analog audio input on
your amp or receiver.
Notes:
• See the table on page 25 for details on how the
DPS-10.5 outputs audio from the D.MIX AUDIO
OUT.
M. Digital Connection
Use an optical or coaxial digital audio cable to connect
one of the DPS-10.5’s DIGITAL 1 or DIGITAL 2 out-
puts (OPTICAL or COAXIAL) to a corresponding digi-
tal audio input on your amp or receiver.
Notes:
• Be sure to configure the digital output (Digital 1 Out
or Digital 2 Out) for PCM (see page 70). Otherwise an
unpleasant digital noise may be heard, which may
damage your equipment.
• The DPS-10.5 doesn’t support AC-3RF, so don’t con-
nect it to the AC-3RF input on a Dolby Digital
receiver.
• See the table on page 25 for details on how the
DPS-10.5 outputs audio from the DIGITAL AUDIO
OUTs.
Connecting a Stereo Amp
R L
D. MIX
L
R
AUDIO OUT
AUDIO IN
Signal flow
Stereo amp
OPTICAL COAXIAL
OPTICAL IN COAXIAL IN
Signal flow
Stereo amp
Only one connection
required! Choose
coaxial or optical