Integra DPS-10.5 - Manual (Page 66)

66
Configuring the DPS-10.5 —Continued
This section explains how to use the onscreen setup
menus.
Using the Onscreen Setup Menus
1 Turn on the DPS-10.5 and your
TV.
On your TV, select the video input to
which the DPS-10.5 is connected.
2 Press the [Setup] button.
The onscreen setup menu appears.
(The menus vary slightly from country
to country.)
3 Use the remote controller’s arrow
buttons to navigate the menus.
Use the Left and Right [ ]/[ ] buttons
to move left and right. Use the Up and
Down [ ]/[ ] buttons to move up and
down.
+10 0 Clear
1 2 3
4 5 6
7 8 9
Input I
+
-
Enter
Set up Retu rn
L 4
L 2 L1 V Off V In
Aspect A-B Repeat
Rsltn Angle Subtitle Audio
L 3
To p M enu Men u
VOL
+
-
V3
TV
Input D M S
DVD Amp VCR
DVD V1 V 2
LM RD
Zoom CH
L Mode
Learning
Search Memory Dimmer Amp Input
Display
Audio
Sel
Zoom On Picture Control
Random Step/Slow
Muting
Angle Subtitle Audio
Aspect A-B Repeat
On Standby T V
T V CH
T V VOL
RC-562DV
Last Memory
Resolution
Mode
Amp Input
Rec
Open/Close
Video Input Video Off
Enter
Setup
Remote controller
Enter
Remote controller
4 When you’ve selected an item,
press the [Enter] button to see
the available options.
5 Use the arrow buttons to select
the options, and press the [Enter]
button to confirm your choice.
6 When you’ve finished, press the
[Setup] button again.
The settings are stored and the onscreen
setup menu closes.
Remote controller
Enter
Enter
Remote controller
Enter
Remote controller