Integra DPS-10.5 - Manual (Page 27)

27
Connecting —Continued
This section shows how to connect the DPS-10.5 to a
standard TV, in which the TV handles both the video and
audio. If your TV has a Dolby Pro Logic decoder built-
in, you’ll be able to enjoy DVDs that bear the Dolby Sur-
round logo.
To fully enjoy the Dolby Digital and DTS soundtracks
available on most DVD-Video discs, or the multichannel
audio of DVD-Audio and SACD, you need a suitable AV
receiver (see page 32).
The DPS-10.5 has three types of video output for use
with standard TVs:
component video , S-Video , and
composite video .
Component video offers the best picture quality, so if
your TV supports it, use a commercially available com-
ponent video cable to connect the DPS-10.5’s COMPO-
NENT VIDEO OUT to the component video input on
your TV. If your TV supports progressive scanning, you
must use a component video connection to take advan-
tage of it.
If you don’t have component video,
S-Video offers bet-
ter picture quality than composite video, so if your TV
supports it, use the supplied S-Video cable to connect the
DPS-10.5’s S VIDEO VIDEO OUT to an S-Video input
on your TV. Failing that, use the supplied
composite
video cable to connect the DPS-10.5’s VIDEO VIDEO
OUT to a composite video input on your TV.
A. Using Component Video
Audio connection not shown here. Make a suitable audio
connection to your TV, AV receiver, or amp.
B. Using S-Video
Audio connection not shown here. Make a suitable audio
connection to your TV, AV receiver, or amp.
C. Using Composite Video
Connecting a Standard TV
VIDEO OUT
COMPONENT
Y
IN
P B
P R
Y
P B
P R
TV
Signal flow
Component
video cable
(RCA)
S VIDEO
VIDEO OUT
S VIDEO IN
TV
S-Video cable
(supplied)*
Signal flow
* The DPS-10.5’s two S-Video
sockets output the same video
signal.
VIDEO OUT
VIDEO
VIDEO IN
D. MIX
L
R
AUDIO OUT
L R
ANALOG INPUT
TV
AV RCA cable
(supplied)*
* The DPS-10.5’s two compos-
ite video sockets output the
same video signal.
(yellow)
(yellow)
(white)
(white)
(red)
(red)
Signal flow