Integra DPS-10.5 - Manual (Page 37)

37
Connecting —Continued
Connect the IR receiver to the DPS-10.5 as shown below.
Controlling Other Out-of-range
Components
For another component that is out of range of its remote
controller, you can use a commercially available IR
emitter to retransmit the remote controller signals
received at the DPS-10.5’s IR IN, as shown below.
Connect the IR emitter to the DPS-10.5’s IR OUT, and
place the IR emitter in front of the other AV component’s
remote control sensor (usually located on its front
panel), as shown below. See the instructions supplied
with the IR emitter.
Only remote controller signals received by the
DPS-10.5’s IR IN are fed through to the IR OUT. Signals
picked up by the DPS-10.5’s remote control sensor are
not.
Notes:
• Before connecting the power cord, complete all of the
necessary audio and video connections.
• Do not use a power cord other than the one supplied
with the DPS-10.5, which is designed exclusively for
use with the DPS-10.5 and should not be used with
any other component.
• Never disconnect the power cord from the DPS-10.5
while the other end is still plugged into a wall outlet.
Doing so may cause an electric shock. Always discon-
nect the power cord from the wall outlet first.
• The DPS-10.5 is shipped with the Standby/On button
in the On position ( ). When the power cord is con-
nected for the very first time, the DPS-10.5 will go on
standby and the Standby indicator will light up.
• To completely shutdown the DPS-10.5, set the
Standby/On button to the Off position ( ).
OUT
IN
IR
DPS-10.5
from connecting block
Miniplug cable
Signal flow
IR IN
IR OUT
Connecting
block
IR receiver
DPS-10.5
IR emitter
Remote controller
Other
component
Signal flow
OUT
IN
IR
Signal flow
DPS-10.5
Remote control
Other component
sensor
from connecting block
Miniplug cable
Miniplug
IR emitter
IR Emitter
Connecting the Power Cord
1 Plug the supplied power cord into the
DPS-10.5’s AC INLET.
2 Plug the other end of the power cord into
a suitable AC wall outlet.
The Standby indicator lights up.
MODEL NO. DPC- 7.4 DVD CHANGER
AC INLET