Invacare Solara Jr. 1106628 - Manual (Page 20)

Solara jr.™ 20 Part No. 1106628
PROCEDURE 4 FRONT RIGGINGS
FRONT
FRIGGINGS
This Procedure Includes the Following:
Installing/Removing
Swingaway Footrest
Adjusting Swingaway Footrest Height
Adjusting Adjustable Angle Flip-up Footplates
Composite/Articulating Footplate Heel Loop Replacement
Installing/Removing Elevating Legrest/Calfpad Assembly
Adjusting the Elevating Legrest/Calfpad Assembly
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may occur.
INSTALLING/REMOVING SWINGAWAY FOOTREST
(FIGURE 1)
INSTALLING
1. Turn the footrest to the side (open
footplate is perpendicular to the wheel-
chair).
2. Insert the footrest assembly mounting pin
into the mounting tube of the wheelchair
frame.
3. Rotate the footrest towards the inside of
the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat STEPS 1-3 for the other footrest
assembly.
5. If necessary, adjust the footrest height.
Refer to ADJUSTING SWINGAWAY
FOOTREST HEIGHT in this procedure of
the manual.
REMOVING
1. Push the footrest release lever inward while rotating the footrest outward.
2. Lift the footrest assembly out of the mounting pin of the wheelchair frame.
3. Repeat STEPS 1-2 for opposite side, if necessary.
FIGURE 1 - INSTALLING/
REMOVING SWINGAWAY
FOOTREST
Footrest Release Lever
Footrest
Assembly
Mounting Tube
Wheelchair
Frame
Footplate
NOTE: Only 60 ° Front Rigging shown for clarity.
Others will attach the same way.
Mounting Pin