Invacare Solara Jr. 1106628 User Manual

Page 49

Advertising
background image

Part No. 1106628

49

Solara jr.™

RECLINER OPERATION (FIGURE 2)

WARNING

ALWAYS make sure that the wheel-

chair is stable in the full reclined (back at

180°) position and the full upright (back

at 90°) position BEFORE using the

recliner option.
Before using the recliner option, make

sure the anti-tipper wheel assemblies

are in the lowest adjustment hole (ad-

justment hole closest to the ground/

floor.)

Before using ANY recline position of this wheelchair, make sure the rear wheels are

in the MOST REARWARD position to maintain the stability of the wheelchair. DO

NOT change the handling/maneuverability of the wheelchair by moving the rear

wheels to any of the forward positions. moving the rear wheels to any of the for-

ward positions will change the center of gravity of the wheelchair, making the

wheelchair less stable.
RECLINER OPTION ONLY - ALWAYS return the back to the upright position

before lifting the wheelchair.
Make sure occupant's hands and body are clear of all pinch points BEFORE reclining

back. Pinch Points exist between spreader bar and gas cylinders. Use caution, other-

wise injury may occur.

1. Make sure the wheelchair is on a level surface.
2. Engage the wheel locks. Refer to USING

THE WHEEL LOCKS in PROCEDURE 8 of

this manual.

3. Inform the occupant of the wheelchair that

the wheelchair is about to be reclined.

4. Make sure occupant's hands and body are

clear of all pinch points.

5. Stand behind the wheelchair and grasp the

stroller handle firmly.

6. Pull up on the handles of the recliner cable

assemblies to activate the gas cylinders.

7. SLOWLY, squeeze the handles of the

recliner cable assemblies and perform one

(1) of the following:
A. RECLINING - allow the back to recline to the desired angle.
B. RETURNING TO UPRIGHT POSITION - Pull up and push the stroller handle towards

the front of the wheelchair until the back is in the upright position.

8. When the back reaches desired angle, slowly release the handles of the recliner cable assemblies.
9. Disengage the wheel locks. Refer to USING THE WHEEL LOCKS in PROCEDURE 8 of this manual.

FIGURE 2 - RECLINER OPERATION

Stroller

Handle

Handle

Gas

Cylinder

TILT/RECLINE

PROCEDURE 9

TILT/RECLINE

Advertising