Invacare Solara Jr. 1106628 - Manual (Page 31)

Part No. 1106628 31 Solara jr.™
4. Re-secure the arm tube to the T-arm post with the two (2) socket screws. Torque to 60-
70 in./lbs.
5. Reattach the arm pad to the arm tube with the two (2) phillips screws. Tighten securely.
6. Repeat for the opposite side, if necessary.
ADJUSTING T-ARM SOCKETS
(FIGURE 9)
NOTE: Perform this procedure if the T-arm is too
loose in the socket or does not easily slide up and
down in the socket.
1. Remove the rear wheels from the wheel-
chair, if necessary. Refer to REMOVING/
INSTALLING REAR WHEELS in PROCE-
DURE 7 of this manual.
2. Loosen, but do not remove the four (4)
hex screws and washers that secure T-
arm socket to T- arm clamp.
NOTE: The T-arm socket will disassemble if the four
(4) hex screws and washers are removed.
3. Slide the T-arm into the T-arm socket
until the locking lever is in the slot in the T-arm socket and an audible "click" is heard.
4. Squeeze the T-arm socket the T-arm clamp together until the socket is flush with the T-
arm.
5. While holding the T-arm socket and the T-arm clamp together, tighten the four (4) hex
screws and washers. Tighten securely.
6. Press in on the locking lever and lift the T-arm straight up and out of the T-arm socket.
7. Repeat STEPS 3-6, if necessary until the T-arm slides in the T-arm socket as desired.
8. If necessary, install rear wheels. Refer to REMOVING/INSTALLING REAR WHEELS in
PROCEDURE 7 of this manual.
ADJUSTING T-ARM TRANSFER ASSISTS AND/OR SIDE
GUARDS (FIGURE 10)
1. Remove the T-arm from the wheelchair. Refer to INSTALLING/REMOVING T-ARMS in
this procedure of the manual.
2. Remove the two (2) socket screws that secure the side guard to the bottom clamp.
NOTE: Adjusting the side guards will directly affect the position of the transfer assist.
3. Perform one (1) of the following:
Small Side Guards - Move the bottom clamp up one (1) of two (2) mounting positions in the side
guard.
Large Side Guards - Move the bottom clamp up one (1) of three (3) mounting positions in the side
guard.
FIGURE 9 - ADJUSTING T-ARM
SOCKETS
Hex Screws and
Washers
T-Arm
Hex Screws and
Washers
T-Arm Socket
T-Arm Clamp
Locking Lever
Slot
PROCEDURE 5 ARMS/POSITIONING STRAPS
ARMS/POSITIONING
STRAPS