Removing/installing rear wheels (figure 1) – Invacare Solara Jr. 1106628 User Manual

Page 41

Advertising
background image

Part No. 1106628

41

Solara jr.™

WHEELS/FORKS

PROCEDURE 7

WHEELS/FORKS

This Procedure Includes the Following:
Removing/Installing Rear Wheels
Adjusting the Quick-Release Axle
Seat-to-Floor Height Adjustment
Adjusting Forks

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all

attaching hardware is tightened securely - otherwise injury or damage may

result.

REMOVING/INSTALLING REAR WHEELS (FIGURE 1)

NOTE: To remove rear wheels, reverse this procedure.
NOTE: If any adjustments (size or position) to the

rear wheels have been made, the anti-tippers must

be adjusted to maintain the 1-1/2 to 2-inch clear-

ance. If this adjustment cannot be made with the

anti-tippers currently installed, a different model

may be required. Consult a qualified technician for

assistance.
1. Push in the detent pin of the quick

release axle and insert the quick release

axle through the center of the rear

wheel.

2. Push in the tip of the quick-release axle

again and insert the axle (with wheel)

into the axle mounting plate on the side

of the wheelchair frame until the assem-

bly locks in place.

WARNING

Make sure detent pin and locking pins of the quick release axles are fully released

BEFORE operating the wheelchair.
The locking pins MUST be protruding past the inside of the axle mounting

plate for a positive lock.
Keep locking pins clean.

3. If the locking pins of the quick release axles are not protruding past the inside of the axle

mounting plate or there is too much movement of the rear wheel assembly in a back and

forth position, refer to ADJUSTING THE QUICK RELEASE AXLE in this procedure of

the manual.

4. Repeat STEPS 1-3 for other rear wheel assembly.
5. Adjust the wheel locks. Refer to WHEEL LOCK ADJUSTMENT in PROCEDURE 8 of this

manual.

FIGURE 1 - REMOVING/

INSTALLING REAR WHEELS

NOTE: Only 12-inch rear wheel is shown. All other

wheels will install/remove in the same manner.

Wheelchair Frame

Rear Wheel

Axle Mounting

Plate

Detent

Pin

Locking

Pins

Quick Release Axle

Advertising