Installing the seat cushion (figure 8) – Invacare Solara Jr. 1106628 User Manual

Page 40

Advertising
background image

Solara jr.™

40

Part No. 1106628

INSTALLING THE SEAT CUSHION (FIGURE 8)

WARNING

The seat cushion IS NOT designed for use in the treatment of pressure sores or

by individuals at risk of developing pressure sores.
Your therapist and physician should be consulted if you have any questions regarding

weight relief, self-examination of the skin, or individual limitations and needs.
Make sure the hook and loop fastening strips are securely attached between the

seat pan and cushion before using.

CAUTION

The cover is designed to protect the foam against a user’s incontinence and to

provide fire retardency so the cushion must not be used without its cover. If the

cover is torn, it must be replaced.
Machine wash cold. Gentle cycle. Mild detergent. NO fabric softeners or bleach.

Tumble dry low or air dry. Warm or hot water or high dryer heat will reduce

flame retardancy.
Wipe down surfaces with a slightly dampened cloth. DO NOT submerge cushion in

water. If cushion foam becomes contaminated because of incontinence, it should

be replaced beause the foam is absorbent and cannot be cleaned.

1. Perform one (1) of the following:

A. FLUSH MOUNT SEAT PAN - Position the cushion with the flap toward the REAR of

the seat pan.

B. DROP MOUNT SEAT PAN - Position the cushion with the flap toward the FRONT

of the seat pan.

2. Ensure the strips of loop fastener are on the underside of the cushion.
3. Align the front edge of the cushion with the front edge of the seat pan.
NOTE: Ensure the cushion is centered on the seat pan. Otherwise the hook and loop fastening strips will

not engage properly.

WARNING

Make sure the hook and loop fastening straps are securely attached between the

seat pan and cushion before using.

4. Secure the cushion to the seat pan, making sure that the strips of loop fastener on the

cushion are securely attached to the strips of hook fastener on the seat pan.

FIGURE 8 - INSTALLING THE SEAT CUSHION

Front Of Cushion Lines Up

With the Front Of the Seat Pan

Cushion

Strip of Loop Fastener

(Attached To Underside

of Cushion)

Flap

Seat Pan

WHEELCHAIR

FRONT

WHEELCHAIR

REAR

Strip of Hook Fastener

(Attached To Top of Seat Pan)

NOTE: Flush mount seat pan

shown.

BACK/SEAT

PROCEDURE 6

BACK/SEAT

Advertising