Invacare Solara Jr. 1106628 - Manual (Page 42)

Solara jr.™ 42 Part No. 1106628
ADJUSTING THE QUICK RELEASE AXLE (FIGURE 2)
1. Remove rear wheel and quick release axle from the wheelchair. Refer to INSTALLING/
REMOVING REAR WHEELS in this procedure of the manual.
2. Depress detent pin in the quick release axle and slide axle through the wheel hub.
3. Increase or decrease end play in the quick release axle by adjusting the locknut on the
end of the quick release axle.
4. Reinstall rear wheel onto the wheelchair. Refer to INSTALLING/REMOVING REAR
WHEELS in this procedure of the manual.
5. Release detent pin ensuring that the locking pins are fully released.
6. Repeat STEPS 3-5 until the quick release axle locks properly.
7. Repeat STEPS 1-6 for opposite side, if necessary.
Quick-Release
Axle
Detent Pin
Locking Pins
FIGURE 2 - ADJUSTING THE QUICK-RELEASE AXLE
Locknut
Rear Wheel
(Reference)
Axle Mounting
Plate
Wheel Hub
(Reference)
SEAT-TO-FLOOR HEIGHT ADJUSTMENT
WARNING
Repositioning the axle plates (seat-to-floor height) MUST be performed by a
qualified technician.
WHEELS/FORKS PROCEDURE 7
WHEELS/FORKS