IBM HANDBOOK 260 - Manual (Page 133)

Storage Architectures and Devices 115
Note: Most feature codes for cables are only orderable against the
attachment device (7204, 7206, 7208). For some cables, the feature codes
have been made available on the system units. In these cases the system
feature code is listed otherwise the attachment device feature code is used.
9xxx feature codes are used for new build orders, whereas 2xxx feature
codes are used for MES orders.
Terminators for Use With This Adapter
This adapter has on-card SCSI terminators that must be removed before the
adapter can be used in a high-availability configuration. The high-availability
configuration is implemented by removing the three on-card differential
terminating resistors (labeled RN1, RN2, and RN3) on the adapter, then
attaching the middle leg connector of the high-availability configuration
DE External
Device 2884
/9160 0.6 52G4291 Device-to-device (where second
device has two connectors),
16-bit wide bus
DE External
Device 2846
/9132 2.5 52G4233 Device-to-device (where second
device has two connectors),
16-bit wide bus
7027 2425
DE External
Device 2885
/9161 4.5 88G5749 Device-to-device (where second
device has two connectors),
16-bit wide bus
7027-HSD 3132 6.0 40H7351 Device-to-device (where second
device has two connectors),
16-bit wide bus
DE External
Device 2870
/9146 12.0 88G5747 Device-to-device (where second
device has two connectors),
16-bit wide bus
7027 HSD 3125
DE External
Device 2869
/9145 14.0 88G5748 Device-to-device (where second
device has two connectors),
16-bit wide bus
DE External
Device 2868
/9144 18.0 88G5746 Device-to-device (where second
device has two connectors),
16-bit wide bus
7027 HSD 3136
M/T FC Length
(Meters) Part
Number Cable Description