IBM HANDBOOK 260 - Manual (Page 220)

202 RS/6000 43P 7043 Models 150 and 260 Handbook
STANDBY mode reflects the configuration during the last boot. To view the
current configuration, access the SP menu after the system boots up. When
you select a memory DIMM, its state will toggle between configured and
deconfigured. Memory DIMMs that are not present are not listed. A memory
DIMM can be in any of the following four states:
Configured by System The memory DIMM is present, and has not
exceeded the number of failures threshold. It is
configured by the system and is available.
Deconfigured by System The memory DIMM is present, but has exceeded
the number of failures threshold. It is
deconfigured by the system and is currently
unavailable.
Manually configured The memory DIMM is present and available. It is
configured by the user through the Service
Processor menus.
Manually deconfigured The memory DIMM is present, but unavailable. It
has been deconfigured by the user through the
Service Processor menus.
7.5.4 Language Selection Menu
The following is an example of the Language Selection Menu.
Note: Your ASCII terminal must support the ISO-8859 character set in order
to properly display languages other than English. This menu allows selecting
languages into which Service Processor and System Firmware menus and
messages are displayed.
7.5.5 CALL-IN/CALL-OUT Setup Menu
The Following is an example of a Call-In/Call-Out Setup Menu.
LANGUAGE SELECTION MENU
1. English
2. Francais
3. Deutsch
4. Italiano
5. Espanol
6. Svenska
98. Return to Previous Menu
99. Exit from Menus
1>