IBM HANDBOOK 260 - Manual (Page 209)

Service Processor 191
• Run-Time Surveillance (Heartbeat Monitoring)
If the device driver is installed and surveillance enabled, the SP monitors
the system heartbeat. If the heartbeat times out, the SP places an
outgoing call. This is different from the Bring-Up phase scenario where
two reboot attempts are made before placing an outgoing call.
7.5 Main Menu
At the top of the MAIN Menu is a listing containing:
• Your Service Processor's current firmware version
• The firmware copyright notice
• The system name given to your server during setup
You need the firmware version for reference when you either update or repair
the functions of your service processor.
Following is an example of the SP Main Menu:
Note: The Service Processor prompt reads either 1> or 2> to indicate which
serial port on the system unit is being used to communicate with the SP.
The following sections cover the different submenus.
Service Processor Firmware
SP Level: px980902
EPROM: 19980902
FLASH: 19980902
Copyright 1997, IBM Corporation
SYSTEM NAME
MAIN MENU
1. Service Processor Setup Menu
2. System Power Control Menu
3. System Information Menu
4. Language Selection Menu
5. Call-In/Call-Out Setup Menu
6. Set System Name
99. Exit from Menus
1>