IBM DS6000 - Manual (Page 183)

Chapter 14. Metro Mirror interfaces 159
14.3.2 Display the Fibre Channel Connection Information Table
The ANALYZE command allows the user to specify the WWNN of the secondary Metro Mirror
volume connected by Fibre Channel links. The analyze pathing reports include the Fibre
Channel Connection Information Table. This information indicates the potential connectivity
of the Fibre Channel ports in the DS6000 where the I/O is issued to each system adapter port
in the DS6000 that is specified by the secondary WWNN.
For example, consider the command shown in Example 14-15.
Example 14-15 ANALYZE NODRIVE NOSCAN command
//IKJEFT01 JOB MSGLEVEL=(1,1),MSGCLASS=A,NOTIFY=user id
//STEP01 EXEC PGM=ICKDSF
//SYSPRINT DD SYSOUT=*
//VOL1 DD UNIT=3390,VOL=SER=DS6030,DISP=SHR
//SYSIN DD *
ANALYZE DDNAME(VOL1) NODRIVE NOSCAN SECWWNN(500507630EFFFCA0)
This command in Example 14-15 generates the table seen in Example 14-16 that shows that
volume
DS6030 with WWNN=500507630EFFFC6F can potentially connect to a device with
WWNN=500507630EFFFCA0 from:
PRI SAID 0000 through secondary SAID 0000 and 0100
PRI SAID 0100 through secondary SAID 0000 and 0100
Example 14-16 ANALYZE NODRIVE NOSCAN command output
FIBRE CHANNEL CONNECTION INFORMATION TABLE
PRIMARY WWNN = 500507630EFFFC6F, SECONDARY WWNN = 500507630EFFFCA0
+------+-------------------------------------------------------------------+
| PRIM | |
| SAID | AVAILABLE SECONDARY SAIDS |
+------+-------------------------------------------------------------------+
| 0002 | ---- |
+------+-------------------------------------------------------------------+
| 0102 | ---- |
+------+-------------------------------------------------------------------+
| 0000 | 0000(0000) 0100(0000) |
+------+-------------------------------------------------------------------+
| 0100 | 0000(0000) 0100(0000) |
+------+-------------------------------------------------------------------+
WHERE THE NUMBER IN PARENTHESIS IS THE RETURN CODE FOR THE SAID, AS FOLLOWS
0000=POTENTIAL CONNECTION
0001=NO POTENTIAL CONNECTION
0002=PRIMARY ADAPTER OFFLINE
ICKDSF - MVS/ESA DEVICE SUPPORT FACILITIES 17.0 TIME: 13:55:57
0003=LINK FAILURE
0004=INVALID TOPOLOGY
0005=ERRORS DETECTED
0006=SECONDARY WWNN INVALID
0007=TIMEOUT DETECTED
14.3.3 PPRCOPY DELPAIR
The DELPAIR command is used to specify a Metro Mirror pair that will be removed from a
Metro Mirror relationship, thus returning the devices to a simplex state. See Example 14-17
on page 160.