Intel Express 5800/120Ld - Manual (Page 115)

Dissasembly and Reassembly 4-43
Replacing the Speaker
1. Power off the system and ensure it is disconnected from the AC power
source.
2. Open and remove the front door and remove the left side panel as described
earlier in this chapter.
3. Tag and disconnect speaker cable connected to the system board. See Figure
1-5, L for the location of the speaker connector.
4. The speaker cable is threaded through three cable clamps. The cable clamps
may be released by pressing the tab located below the head of the clamp. If
any of the cable clamps cannot be released, carefully cut the clamps to allow
access to the speaker cable.
5. Remove the screw securing the speaker to the right side of the chassis.
Remove the speaker. See Figure 4-41.
Figure 4-41. Removing the Speaker
6. Using the screw removed in Step 5, mount the replacement speaker to the
right side of the chassis.
7. Connect the speaker to the system board.
8. Install cable clamps as necessary.
9. Install the left side panel, front door, and connect the ac power cord.
10. Power up the system.