Intel Express 5800/120Ld - Manual (Page 78)

4-6 Dissasembly and Reassembly
Removing Side Panels
To install options in the system, you must remove the side panel on the left side
of the system (as viewed from the front). The side panel on the right side of the
system (as viewed from the front) only has to be removed when adding SCSI
hard disk drives to the non-hot-swap drive bays.
! CAUTION
For proper cooling and airflow, do not operate the system
with the side panels removed. Always replace the panels
before powering on the system.
! WARNING
If you are removing the side panel after the system is set up,
you must first power off the system and all external devices
and then Unplug the system power cord
To remove the left side panel:
1. Power off the system and ensure it is disconnected from the ac wall outlet.
2. Open and remove the front door following procedures in the previous
section.
3. The left side panel is secured to the chassis with one thumbscrew
(Figure 4-4A). Remove the screw securing the side panel. Save the screw for
reattaching the side panel.
4. Using the indentation on the side of the panel, slide the side panel toward the
front of the system. This unlocks the locking fingers behind the side panel.
5. Pull the side panel out and away from the chassis (Figure 4-4).
A
B
Figure 4-4. Removing the Left Side Panel