Intel Express 5800/120Ld - Manual (Page 118)

4-46 Dissasembly and Reassembly
Figure 4-44. Removing the LED Assembly Sockets
8. Spread the two rear tabs of each of the four LED sockets and pull the LED
out the rear of the socket as shown in Figure 4-45. Save the sockets for use
in the next step.
Figure 4-45. Removing the LED Assembly Sockets
9. Position the four LED’s of the replacement assembly into the appropriate
holes in the mounting bracket.
10. Snap an each LED into an LED socket.
11. Snap each LED socket into its hole in the bracket assembly.
12. Position the LED Assembly cables through the cable clamps to the system
board. Install and secure cable clamps as required.
13. Connect the LED cable to the system board. See Figure 1-5, F.
14. Secure the LED Assembly mounting bracket to the front of the chassis using
the two screws remove in Step 5.
15. Install the left side panel and the front door.
16. Connect the ac power cord and power up the system.