Intel Express 5800/120Ld - Manual (Page 98)

4-26 Dissasembly and Reassembly
Figure 4-20. Removing a Hard Disk Drive and Carrier
4. Place the drive carrier on an antistatic surface with the four mounting
screws facing up.
5. Remove the hard disk drive from the disk carrier. See Figure 4-21.
Figure 4-21. Removing/Installing a Hard Disk Drive to the Carrier
6. Remove the new drive from its protective wrapper, and place on an
antistatic surface.
! CAUTION
Observe static precautions. Use an antistatic wrist strap.
7. Record the drive model and serial numbers in the equipment log.
8. Install the replacement drive onto the drive carrier.
! Place the drive on the carrier, with its connector facing the rear of the
carrier.
! Turn the drive and carrier over and secure the drive in the carrier with
the four screws supplied with the disk drive. See Figure 4-21.