Intel Express 5800/120Ld - Manual (Page 83)

Dissasembly and Reassembly 4-11
Removing and Installing a Processor
1. Power off the system and ensure it is disconnected from the AC power
source.
2. Open and remove the front door and remove the left side panel as described
earlier in this chapter.
! CAUTION
Observe static precautions. Use an antistatic wrist strap.
Hold the processor only by its edges.
3. If the system has one processor and you are adding a second processor, then
you must remove the termination board in the secondary connector and store
it appropriately.
4. If the system has one processor and you are replacing it, leave the terminator
board intact in the empty secondary processor connector. Remove the
processor you want to replace.
5. If the system has two processors and you are replacing one or both, remove
the appropriate one(s).
6. Pull the retention latches, (Figure 4-8,A) out away from the edges of the
cartridge to free them from the retention module.
7. Lift the cartridge upward, out of the retention module and place it on a
grounded, static-free surface or conductive foam pad.
8. Put the old processor in a piece of conductive foam and store in an antistatic
package.
Figure 4-8. Removing a Processor
9. Remove the new processor from its antistatic package and place
it on a grounded, static-free surface or conductive foam pad.