Inter-Tel 8622 - Manual (Page 34)

20
Inter-Tel ® Model 8622 Endpoint User Guide
BASIC
FEATURES
F
EATURES
U
SED
W
HILE ON A
C
ALL
The following features are primarily used for active or incoming calls.
Placing Calls On Hold
When you place a call on hold, the held party hears music on hold or silence, depend-
ing on your system configuration. While the call is on hold, the system periodically
rings your endpoint as a reminder.
To place a call on hold:
1. Press or .
2. Hang up or place another call.
To return to a held call:
1. Lift the handset or press (handsfree).
2. Press or the flashing button.
If more than one call is on hold, switch between held calls (call hop) by pressing the
flashing
button assigned to the call.
Using Call Park
Use Call Park to place calls on hold to a designated “orbit” location. After the call is
parked to the orbit location, it can be picked up (answered) by any subscriber.
To use Call Park:
1. During the call, press or .
2. Enter a 1- to 10-digit orbit number (for example, ), and then press .
A confirmation notice appears.
3. Dial the extension number for which the parked call is intended, and then
announce the parked call and the orbit number.
4. Hang up. You are disconnected from both parties.
If the parked call is not picked up, it will be redirected to the subscriber that parked
the call after the Park Recall timer expires (about two minutes).
To pick up a parked call:
1. Press or .
2. Enter the orbit number, and then press .
3 6
LINE
LINE
PARK 9 8
1 1 1 #
SUCCESSFULLY
CALL PARKED
PICKUP 9 9
#