JVC ENLPT0736-001B - Manual (Page 16)

Filename [HM-HDS4EX_04Basic.fm]
Masterpage:Left
16
EN
Page 16 April 2, 2003 2:20 pm
INITIAL SETTINGS (cont.)
Preset Download
Auto Channel Set by Downloading
from TV/Auto Clock Set/Auto Guide
Program Number Set
NOTES:
● For details, refer to the instruction manual of your TV.
● In the area where no TV station transmits a PDC (Programme
Delivery Control) signal, the recorder can perform neither
Auto Clock Set nor Auto Guide Program Number Set.
● If there is a power cut, or if you press
1 or MENU while
downloading or set up is in progress, it will be interrupted; be
sure to turn off the recorder power once and try again from the
beginning.
● Auto Clock Set may not function properly depending on the
reception condition.
● On this recorder, the characters available for station names
(ID) are A–Z, 0–9, –, f , + and I (space). Some names of
downloaded stations may differ from those of your TV
(
੬
pg. 92).
If you have connected the recorder to your TV via a 21-pin
SCART cable (
੬
pg. 12), the recorder will automatically
perform Preset Download instead of the Auto Set Up in step D
on page 15. After downloading, the recorder sets the clock and
Guide Program numbers automatically.
A
Perform Preset Download.
Press OK. The AUTO SET/T-V LINK display appears on
the TV screen.
ATTENTION
You can use this function only with a TV offering T-V Link,
etc.* Be sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may
differ by system.
?
Perform steps A to C of “Auto Set Up” on page 14 before
continuing.
Press
rt
to move the
highlight bar (pointer) to
“T-V LINK” and press OK or
e
.
Preset positions on the front display panel increase from
“CH1”; do NOT press any button on the recorder or remote
control until the front display panel shows clock time,
“(CH) 1” or “– –:– –” as illustrated on page 17.
● If you are using the on-screen
display, the T-V LINK screen
will appear. Then the GUIDE
PROG SET screen will appear
during Guide Program
Number Set. When Preset
Download is completed,
“COMPLETED” appears for
about 5 seconds, then the
normal screen appears.
● If you press any button on the
recorder or remote control
while downloading is in
progress, it will be interrupted.
HM-HDS4EX.book Page 16 Wednesday, April 2, 2003 3:55 PM