JVC ENLPT0736-001B - Manual (Page 20)

Filename [HM-HDS4EX_04Basic.fm]
Masterpage:Left
20
EN
Page 20 April 2, 2003 2:20 pm
SAT CONTROL SET (cont.)
Setting satellite receiver’s brand and
channel
After installation, set the satellite receiver’s brand and
channel correctly; otherwise, the Satellite Controller
cannot work correctly.
A
Turn on the satellite receiver.
Turn on the satellite receiver’s power.
B
Access the Main Menu screen on the
recorder.
Press MENU.
C
Access the Initial Set screen.
A Press
w e
to move the arrow to “INITIAL SET UP”,
then press
t
.
B Press
w e
to move the arrow to “INITIAL SET”, then
press OK.
D
Access the Sat Control Set screen.
E
Enter the satellite receiver’s brand.
F
Select the satellite receiver’s channel for
testing.
● Turn on the TV and select the AV mode.
● Slide TV/CABLE/SAT switch to the right.
?
Press
rt
to move the
highlight bar (pointer) to
“SAT CONTROL SET”, then
press OK or
e
.
Press the appropriate number
keys to enter the brand code
from the list on page 21, then
press OK.
● If the brand code you entered
is invalid, the code field will
be reset. Enter the correct
brand code again.
● If the recorder is in playback or
recording mode, you cannot
set the brand code.
Press the appropriate number
keys to enter one of the
channel positions on the
satellite receiver, then press
OK.
● You can select the channel
position between 1 to 999.
● After pressing OK, the recorder
enters the Test mode.
HM-HDS4EX.book Page 20 Wednesday, April 2, 2003 3:55 PM