John Deere AUTOTRAC OMPFP11320 - Manual (Page 3)

Contents
Page
Safety
Recognize Safety Information ............................05-1
Understand Signal Words...................................05-1
Follow Safety Instructions...................................05-1
Practice Safe Maintenance.................................05-2
Handle Electronic Components and
Brackets Safely ..............................................05-2
Use Seat Belt Properly .......................................05-3
Operate Guidance Systems Safely ....................05-3
Use AutoTrac Controller on Approved Vehicles ..05-3
Safety Signs
Automatic Guidance System Detected...............10-1
AutoTrac Controller
AutoTrac Accuracy .............................................15-1
General Information............................................15-1
AutoTrac Settings ...............................................15-2
Activity Monitor ...................................................15-2
AutoTrac Controller Troubleshooting
AutoTrac Controller ............................................20-1
Diagnostic Readings...........................................20-2
Stop Codes.........................................................20-3
AutoTrac Controller—Raven
AutoTrac Controller— Raven Calibration ...........25-1
Failed Calibrations..............................................25-8
Necessary Conditions for Activating AutoTrac ...25-9
AutoTrac Controller—Raven
Diagnostic Addresses ..................................25-10
AutoTrac Controller—Raven
Diagnostic Trouble Codes ............................25-12
GS2 Display 1800
Automatic Guidance System Detected...............30-1
Enabling System.................................................30-1
Activating System ...............................................30-1
GreenStar Run Page ..........................................30-2
Enabling AutoTrac ..............................................30-6
AutoTrac Status Pie............................................30-7
Reactivating AutoTrac on Next Pass ..................30-8
Deactivating AutoTrac ........................................30-8
Guidance Settings ..............................................30-9
AutoTrac Settings .............................................30-10
Advanced AutoTrac Settings ............................30-13
StarFire ............................................................30-16
Page
Troubleshooting—GS2 Display 1800
Trouble Codes ....................................................35-1
Diagnostic Addresses.........................................35-1
Guidance Alarms ................................................35-3
AutoTrac Deactivation Message.........................35-4
Diagnostic Addresses.........................................35-5
GS3 2630 Display
Automatic Guidance System Detected...............40-1
Enabling System.................................................40-2
Activating System ...............................................40-3
Deactivating System...........................................40-3
Setup ..................................................................40-4
StarFire ..............................................................40-5
GS3 2630 Advanced Settings
Tuning Recommendations..................................45-1
Recommended Tuning Settings .........................45-3
Optimizing AutoTrac Controller Performance .....45-4
Tuning Tips, Tricks, and Precautions..................45-9
Troubleshooting ..................................................45-9
Specifications
Unified Inch Bolt and Screw Torque Values........50-1
Metric Bolt and Screw Torque Values.................50-2
EC Declaration of Conformity .............................50-3
Original Instructions. All information, illustrations and specifications in this
manual are based on the latest information available at the time of publication.
The right is reserved to make changes at any time without notice.
COPYRIGHT © 2011
DEERE & COMPANY
Moline, Illinois
All rights reserved.
A John Deere ILLUSTRUCTION ® Manual
i 090811
PN=1