John Deere AUTOTRAC OMPFP11320 - Manual (Page 47)

Troubleshooting—GS2 Display 1800
CF86321,0000333 -19-23MAY11-2/2
CF86321,0000334 -19-23MAY11-1/1
Prescription Error Controller is setup to accept prescriptions. No controller prescription has been selected.
Prescription Error Prescription rate is out of controller range.
Controller Unit of Measure Error Controller will only operate when using metric units.
Controller Unit of Measure Error Controller will only operate when using English (US) units.
Controller Unit of Measure Error Controller will only operate when using metric or English (US) units.
Controller Operation Error Invalid operation selected for controller.
Prescription Warning Out of field prescription rate is now being applied.
Prescription Warning Loss of GPS signal has occurred. Loss of GPS prescription rate is now being applied.
Prescription Warning Controller does not support selected prescription.
INFO
AutoTrac Deactivation Message
AutoTrac deactivation message–Each time AutoTrac
is deactivated text is displayed indicating the reason
why AutoTrac deactivated. Messages are also displayed
as to why AutoTrac did not activate. The deactivation
messages display for 3 seconds and then disappear.
AutoTrac Deactivation Message
Deactivation Message Description
Steering wheel moved Operator turned steering wheel
Speed too slow Vehicle speed is below minimum required speed
Speed too fast Vehicle speed is above maximum allowed speed
Invalid gear Vehicle operating in an invalid gear
Track number changed Track number changed
Invalid GPS signal SF1, SF2, or RTK signal was lost
Steering Controller fault See John Deere dealer
Invalid display messages Check display settings
Invalid display settings Check guidance settings and Track 0 setup
No AutoTrac Activation No AutoTrac Activation on GS2
Heading error too large Vehicle is at an angle greater than 45 degrees from track
Offtrack error too large Vehicle not within 40% of track spacing
Out of seat Out of seat too long
Oil temp too cold Hydraulic oil not above minimum required temperature
No TCM corrections Make sure TCM is turned on
Invalid Steering Controller activation Need Steering Controller activation code.
See John Deere dealer.
FICA in diagnostic mode Fuse is in diagnostic slot in vehicle fuse box. remove fuse.
Header off Header was turned off
Road mode In transport gear
Invalid Steering Controller voltage See John Deere dealer
Reverse timeout In reverse gear for more than 45 seconds
Vehicle too slow AutoTrac below minimum speed
Curve too sharp Maximum curvature has been exceeded
Vehicle not moving in a forward direction Vehicle must be in forward gear to activate
Vehicle shutting down Vehicle is shutting down
Gear data error See John Deere dealer
Resume switch error See John Deere dealer
Keyswitch error See John Deere dealer
SPFH AutoTrac switch is not on Make sure SPFH AutoTrac switch is turned on
SPFH Quick Stop switch is on Make sure SPFH Quick Stop switch is turned off
35-4 090811
PN=47