Juniper Networks IDP SERIES IDP250 - Manual (Page 17)

Table 6: System Status LED States (continued)
Description Status LED
Power failure. Slowly blinking red Fault
Fan failure. Quickly blinking red
Overheating. Solid red
Heat and power are normal. Off
USB Port
The appliance has a USB port you can use to reimage the appliance, if necessary. The
part number is IDP-FLASH (IDP75, IDP250, IDP800) or IDP-FLASH-8200 (IDP8200).
Serial Console Port
The console serial port provides access, using an RJ-45 connector, to the command-line
interface (CLI).
NOTE: Although both the console serial port and the management port use
RJ-45 connectors, do not plug the network cable into the console serial port.
Management Interface Port
The management interface port is a 10/100/1000 Mbps Ethernet port. In the configuration
and logs, the port is
eth0 . Use this port as a dedicated management port, connecting the
device to a switch accessible by your management subnet.
The IP address you assign the management port is the IP address you use to connect to
the Appliance Configuration Manager (ACM) when you initially configure the device. It is
also the address the Network and Security Manager (NSM) uses to connect to the device.
Figure 2 on page 5 shows the management interface port LEDs.
Figure 2: Management Interface Port LEDs
Table 7 on page 6 describes the management interface port LED states.
5 Copyright © 2012, Juniper Networks, Inc.
Chapter 1: Hardware Overview